installed updated 0_09092010 did fact-default went to auto search pressed green button didnt get this after you see this screen you will get another with a list of areas pick your net id or nearest area and press ok let the box do the rest thats it it went straight to tv channles / radio channle box tcp 8/8 sig strength 56 complete exit then goes back to easy installation anything im doing wrong here guys ? came across nothing to select net id followed e45s tut Ok lets start at the start and follow this ok 1 menu >> installation >>> factory default your box password >>> 0000 2 unplug your box from the power socket wait 30 seconds and plug back in 3 next screen you see is the scan screen scroll down to auto and press ok 4 next screen you get put your provider on top leave the next one alone set to default NETWORK 5 press the green button on your remote only let the box scan 6 next screen you get list of net id find your one or nearest to you and highlight it and press ok leave the box to scan let me know then when this is done what you get this is were its skipping 6 next screen you get list of net id find your one or nearest to you and highlight it and press ok its skips the id scan shows 8 and flips to installation again do i still need to config com port with box plugged into router
update ran my old cable splitter with no ethernet cable got all the channles in only 1 net id - 60/40 working channles some paid some not - all sports missing most of the other regulars there update for some odd reason if i just use the ethernet 60/40 channles no sky sports if i plug my spliter in as well there all there what ever works right
did you scan your box on all channels or Network you either did not turn the box off at the back to kill the power after you factory defaulted the box fully. you need to scan your box on a direct feed NOT split feed you need a cable feed in the box as well as an net feed and if you are only paying for the broadband and not cable i would say your cable feed is to low Also make sure you put the 780 firmware on your box as the 750 firmware has same date if unsure flash the box again Also please update this post if you got a new box thanks http://forums.afterdawn.com/t.cfm/f-59/a789_question-879459/
did you scan your box on all channels or Network -- yup you either did not turn the box off at the back to kill the power after you factory defaulted the box fully -- had my wife time 30 secs turned of at the back you need to scan your box on a direct feed NOT split feed scanned on split cable in box + ethernet cable 1 without the other resulted 60/40 and if you are only paying for the broadband and not cable i would say your cable feed is to low -- i have 10 meg vm Also make sure you put the 780 firmware on your box as the 750 firmware has same date if unsure flash the box again i did - i got it from kv Also please update this post if you got a new box thanks nah i found the problem loose connection on clip between power board and main board - fixed it myself -
Because you have a 10mg Broadband feed dont mean that your split cabel feed is strong enough signal wise to pull in the lower freq channels check your signal on your box choose a channel and then press info button if your signal is lower than 75% you will suffer channel loss and breakup channel loss is nothing to do with your Broadband feed as the channels come thru the cable feed
