1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Brand New Xbox & a burn component PLS help

Discussion in 'Xbox - Hardware mods' started by Microcutz, Jan 26, 2005.

  1. Microcutz

    Microcutz Member

    Joined:
    Sep 22, 2004
    Messages:
    7
    Likes Received:
    0
    Trophy Points:
    11
    K heres my problem i installed the X3 on my little bros new XB and in doing so i knocked the solder away from a component and in my "efforts" to solder it back i removed it form the m/board , hmm at this point i felt it go downhill so as I failed to resolder it ended up burning it. I dont know what type of component it is I think its a resistor but not completely sure


    it looks very similer to this

    [​IMG]
     
    Microcutz, Jan 26, 2005
    #1
  2. big_g-man

    big_g-man Regular member

    Joined:
    Jul 18, 2004
    Messages:
    164
    Likes Received:
    0
    Trophy Points:
    26
    that sucks...
     
    big_g-man, Jan 29, 2005
    #2
  3. Twinski

    Twinski Regular member

    Joined:
    Dec 29, 2004
    Messages:
    160
    Likes Received:
    0
    Trophy Points:
    26
    it's called a trace....and in other words, you're phucked
     
    Twinski, Jan 30, 2005
    #3
  4. noobiemod

    noobiemod Member

    Joined:
    Jan 30, 2005
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    11
    hi there im a totall noob im just writing to say your not phucked (well not completely neway) if u have a phone around you may be able to get hold of a bloke specialised in soldering i only know this cause i went thru the same thing m8 cost me 25 quid
     
    noobiemod, Jan 30, 2005
    #4

Share This Page