1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Wiring and Soldering a "Solderless Chip"

Discussion in 'Xbox - Hardware mods' started by jl802, Mar 17, 2005.

  1. jl802

    jl802 Member

    Joined:
    Jul 27, 2004
    Messages:
    9
    Likes Received:
    0
    Trophy Points:
    11
    First of all I have a 1.4 version Xbox.After about 6 months of unreliability, I decided to solder and wire it in. Hopefully I'm nearly done. My question, there are 2 d0 POGOS and only one place to solder to (2 if you count front or back) on the motherboard according to all the guides. Which hole do I need to solder to on the mod chip and do I need to do anything further with the other hole other than remove the pin?
     
    jl802, Mar 17, 2005
    #1
  2. mickrick

    mickrick Member

    Joined:
    Nov 21, 2002
    Messages:
    61
    Likes Received:
    0
    Trophy Points:
    16
    Umm, it would help if you told us what modchip you have and point us at the installation instructions.
     
    mickrick, Mar 23, 2005
    #2
  3. jl802

    jl802 Member

    Joined:
    Jul 27, 2004
    Messages:
    9
    Likes Received:
    0
    Trophy Points:
    11
    An executer 2.3 lite +.
     
    jl802, Mar 23, 2005
    #3

Share This Page