1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

VBR Bias, Quality Prec, and VBR Passes... are they fine at defailt settings?

Discussion in 'DVD / BD-Rebuilder forum' started by -Marlin-, Sep 18, 2005.

  1. -Marlin-

    -Marlin- Regular member

    Joined:
    Jul 25, 2005
    Messages:
    90
    Likes Received:
    0
    Trophy Points:
    26
    Do these need to be changed for any reason? I have the guide for RB, but am looking for a bit more in depth explanation.

    I see that VBR Bias is set right now for a more consistent quality as opposed to giving banwidth or whatever to scenes that need more, and quality prec can give better results in colour blockiness or edge artifact... I get that much. But how does one know when to alter these and by how much?

    Also, I can't find the thread anymore on this board where the number of passes of CCE was discussed, as I am curious as to when there is no more benefit. I seem to recall it being 4 passes?
     
    -Marlin-, Sep 18, 2005
    #1
  2. squizzle

    squizzle Active member

    Joined:
    Apr 19, 2004
    Messages:
    2,271
    Likes Received:
    0
    Trophy Points:
    66
    I believe you're right about this, but I'm not 100% sure either.

    I did notice some artifacts when I first started using these programs, but I've been using the Undot AVISynth filter and since then I've seen none at all.
     
    squizzle, Sep 19, 2005
    #2
  3. -Marlin-

    -Marlin- Regular member

    Joined:
    Jul 25, 2005
    Messages:
    90
    Likes Received:
    0
    Trophy Points:
    26
    Hmmmm.... what an Undot AVISynth filter?
     
    -Marlin-, Sep 19, 2005
    #3
  4. squizzle

    squizzle Active member

    Joined:
    Apr 19, 2004
    Messages:
    2,271
    Likes Received:
    0
    Trophy Points:
    66
    squizzle, Sep 20, 2005
    #4

Share This Page