I Installed the Pioneer DVR-509 16X and also installed nero and decrypter and shrink. I also installed forced aspi and read all the instructions carefully, once i pulled up the aspi check it said none of the files were installed. oh and also the dvd burner only plays cds not dvds. please help. very fustrating.
Hey, I'm still looking for the jumpers on my wife, to switch her from Master to Slave <grin>... If one device is set to "Cable Select" make sure they are ALL on Cable Select, else, use Master and Slave as mentioned above !
I dont think is the jumpers because if the dvd burner is being detected the jumpers are set correctly, if the jumpers were set incorrectly it would not be detected, also if possible try to isolate the drive (I mean put it on a separate cable from the HD),so it does not have to share cable bandwith with the HD, try to check if it a software problem, use it on another computer if it works correctly you can be almost sure if a software problem, also remember to update the firmware many times this solves problems, if the problem persist, RMA it
Both cannot be Slave.. The one on the end of the IDE cable had to be Master and the next down has to be Slave...
Hey, I have used the TMPGEnc Program and I can finally get it to show up on the DVD player. However that only worked when I Burned one video file. If I add the others I always get an error after it has already gone through all of the other video's... Can anyone help?
