1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

About mode1 and mode2

Discussion in 'CD-R' started by Schweyer, Mar 30, 2003.

  1. Schweyer

    Schweyer Member

    Joined:
    Mar 30, 2003
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    11
    I have some cue/bins. When I open the cue file it says mode1. But when I go to nero,go to burn image, select all files, pick the cue for the pc game. And under info in nero it says data(mode2). Is this fine. Should I leave it. Could someone please help. Thanks
     
    Last edited: Mar 30, 2003
  2. aldaco12

    aldaco12 Active member

    Joined:
    Nov 6, 2002
    Messages:
    2,544
    Likes Received:
    0
    Trophy Points:
    66
    You have 'MODE2' because you are NOT choosing correctly File-->Burn Image--->Load the CUE file. Probably you load the BIN file with an old version of Nero (before 5.5.9.9).

    On Nero 5.5.9.9 and above you should see this:

    [​IMG]

    An then you'll have this write screen, where you cannot select anything except TAO/DAO:

    [​IMG]

    On older versions of Nero you'll need to select 'all files'. Then:

    1) if you load the CUE file (NOT the BIN!!) you'll see the same Write dialog window above shown;
    2) if you load the BIN file (you do this when you don't have a CUE file and you're unable to wrte one for yourself), you'll see a dialog window (see below) where you have to select manually 'MODE1' and RAW to put the correct image settings for a PC CD:
    [​IMG]

    After clicking on OK you're again on the Write dialog window (see above).

    So, next time, [bold]please[/bold], follow the guide step-by-step...
     
    Last edited: Mar 30, 2003

Share This Page