1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

booting GCOS 1.5 on Viper and using AR codes

Discussion in 'Nintendo Gamecube - General discussion' started by Kafluke, Jul 30, 2006.

Thread Status:
Not open for further replies.
  1. Kafluke

    Kafluke Active member

    Joined:
    Jul 17, 2004
    Messages:
    1,368
    Likes Received:
    0
    Trophy Points:
    66
    I have decided to flash my Viper with GCOS 1.5 and I couldn't be happier. The better compatability and forced NTSC is a dream. The only down side is that I can't figure out how to load my AR codes now. The cobra 1.6 bios supported this natively and it was a simple process to enable them. Does anybody know how I would go about enabling AR codes with the GCOS 1.5 bios booting off my ViperGC?
     
    Kafluke, Jul 30, 2006
    #1
Thread Status:
Not open for further replies.

Share This Page