i get no channels at all on my dbox ive done scans with no luck if you guys could check my settings thanx my provider was t/wet now v/m i have a dbox2 and the image is sportster 2.0 i think my settings are scan for services = all services boquet = leave existing cable provider = sym6952 fast scan = on manual scan = off freq sybol rate = 6952 FEC = 1/2 polorization = H some more info to assist my Ber is 4398 ....? it keeps rising even tho i have taken the cable lead out?? snr is 5976 sig is 62752 in emu selection i have ''EVOCAMD, EVOCAM Alternate and SBMCAMD'' the selected 1 is EVOCAMD Any more info needed let me know thanx in advance
Disable fast scan and choose bruteforce if available. Without a valid channel tuned in the numbers for ber and so on are not sensefull.
Try this had similar problem to you with VM in NThell area Managed to get all my channels back by playing around with box. Sorted it by; unplug and plugged back box at mains, go into scan set up changed cable provider from Cable UK Sym 6887 to Cable UK Sym 6952 (can only think VM are now using Tell*pest settings) New Scan setup Scan for Services------All Services Bouquet----------------overwrite Exsisting Cable Provider---------Cable UK Sym 6952 Fast Scan--------------Off Manual Scan------------Off Frequency Symbol Rate FEC--------------------3/4 polarization-----------H When finished it says scan sucessfull. So then home button several time to exit, unplug box from mains and replug it in. Wait for it to reboot up and "HEY PRESTO" Happy Days again found 334 channels and 182 transponders. So in your case try changing cable provider sym6952 to sym6887 Best of luck....Alan
tried these settings still no luck not even getting transponders....im in bham area if thats any help anymore help would be appreciated. thanx
Try all other options in the provider line. Remove all splitters and connect your box directly to your feed.
i have nothing in the bouquet editor ?is this normal my service scan for bouquet setting is ''leave existing'' but i dont think their is 1 existing?
I understand your settings are: scan for services = all services boquet = leave existing cable provider = sym6952 fast scan = on manual scan = off freq sybol rate = 6952 FEC = 1/2 polorization = H change to these settings; Scan for Services------All Services Bouquet----------------overwrite Exsisting Cable Provider---------Cable UK Sym 6887 Fast Scan--------------Off Manual Scan------------Off Frequency Symbol Rate FEC--------------------3/4 polarization-----------H don't forget to unplug from mains before alterations and afte re-scan. Make sure you are in 1.73 ultra mode
I managed to pick up 30 transponders and 91 channels but the sound is only coming but no picture however....when i push the cable and hold it their in the dbox i get a picture when i let go.... back to only sound and even thats not clear ? any suggestions>? ive tried a signal booster and get absolutely nothing with that no sound or transponders could it be the lnb thing is nackered or my f connecter is not good? last question im in bham how many channels should i be receiving? thanx
this is what i use t/wet cable^ which i connect onto....one of these and then into dbox....?is this ok
Ok, the second one is a F-socket to coax adapter. Unplug your box, use pliers and compress the slot for the plug pin at the box carfully a little bit.
sorry but can i ask have i got the wrong connector? because id rather get the correct connecter than do a plier job .. thanx
The connector is the right one. It looks like the little slot for the plug centre pin is too wide because the preowner didn't use the plug carefully enough.
ohrite thanx for ur help mgb..... last question lol how many channels should i be reciving im in bham area west mids t/wet
