1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

cpu boot problem

Discussion in 'PC hardware help' started by link1227, Oct 24, 2007.

  1. link1227

    link1227 Member

    Joined:
    Oct 24, 2007
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    11
    Hello everyone, I was using my front usb panels 3 days ago on my cpu now they dont work at all. Not only that, when i have something plug into my 4 remaining USB ports my cpu is slow to boot and during the boot my PS/2 keyboard doesn't work!! can anyone help
     
    link1227, Oct 24, 2007
    #1
  2. ddp

    ddp Moderator Staff Member

    Joined:
    Oct 15, 2004
    Messages:
    39,205
    Likes Received:
    146
    Trophy Points:
    143
    check in the bios to see if you have usb drives enabled for booting & check that all usb ports whether usb1 or usb2 are enabled.
     
    ddp, Oct 24, 2007
    #2
  3. link1227

    link1227 Member

    Joined:
    Oct 24, 2007
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    11
    i tried what u said but my keyboard isn't working until i get to the account select page
     
    link1227, Oct 25, 2007
    #3
  4. itpro1000

    itpro1000 Guest

    Clear the CMOS. Either take the lithium battery out for about 5 minutes or clear by jumper setting. Move the cmos jumper, located near the battery, over the the other 2 pins for about 30 sec. then move it back to the original pin position. This should bring the board back to OEM settings. the is a good graphic of the CMOS jumpter: http://www.winfuture-forum.de/index.php?act=ST&f=1&t=96195
     
    Last edited by a moderator: Oct 31, 2007
    itpro1000, Oct 31, 2007
    #4

Share This Page