I'm having issues w/my iLo (error message) and would like to return it to it's origianl out of the box state. Any suggestions?
It's taking awhile to get started after powering on, clicking noise, until I get an error message Ox810D0004. The hd is no longer functional. I put the original 80gb drive back in and it works fine. I had replaced it w/a 320gb hd and it worked great for a couple of weeks.
That error code is relative to a HDD problem Is the recorder leaving Hello after about 12 sec or staying there for some I min. If -I min it would reflect that the HDD is not being recognized The RHD04 will format a larger than 80gb to the 80gb if compleatly erased in the tools menu That it did work for a few weeks and at full 320 GB. I gather that you followed the proper procedure for a larger than 80gb drive. It would require a PC and the proper files installed. If so even if you did Erase the entire disk it should have formatted it to 80 gb and would work If so I can only guess that the drive has problems Try these sites, they have very good stickys on the subject http://www.techolio.com/ http://www.techolio.com/
What a bummer! After all the work, talk about bad luck. What's the current firmware version on the HD04? To find it, press setup and and it's the S/N number, just fishing as to see first if the HD04 is at the most recent update (0201) which would show up in your S/N at this point xxxx-xxxx-0201-xxxx. If 201 is not installed, the solution might be just updating it, fingers crossed ! CC
