DVD RB 1.27.3 exits when it gets to Encodeing

Hi,

I just installed dvd rebuilder 1.27.3.

Everything works till i hit encode and then it just exits.

Same thing happens in 1 lick mode, preperation works, and as soon as it come to encode it exits to windows.

I followed the install guide on this forum.

I was useing HC enc and i havent changed any settings.

NE1 else have this problem.

I am useing the lastest avisyth which is 2.5.7

Thanks...

 

Here is the log

-----------------
[20:54:23] Phase I, PREPARATION started.
- DVD-RB v1.27.3
- AVISYNTH 2.5.7.0
- HC v0.22.0.0 encoder selected
- "Movie Only" mode is enabled.
- Source: DEATHATAFUNERAL
- VTS_01: 2,554,096 sectors.
-- Scanning and writing .D2V & .AVS files
-- Processed 130,226 frames.
-- Building .AVS and .ECL files
- Reduction Level for DVD-5: 100.0%
- Overall Bitrate : 6,076Kbs
- Space for Video : 4,150,728KB
- HIGH/LOW/TYPICAL Bitrates: 6,430/410/6,076 Kbs
[20:58:31] Phase I, PREPARATION completed in 4 minutes.


Now when I hit encode the program just exits to windows as if i where to close it. No error msg's.

 

Can you try with a movie that needs encoding?

 

Yeah i just this one for an example log, didnt even realise that it does not require encodeing XD.

I tried it with 300, Van Helsing, etc before and got the same problem.

 

Are these files already on your HDD or are you trying to read from the disc?

 

Yeah mate there on the HDD.

I got them from original DVD's. With 300 i ripped it with AnyDVD and i also tried DVD decripter. But i dont think the problem is there.

Could it be a Problem With AviSynth?? I reInstalled that a few time as well.

 

It could be but usually you would get an error message. Uninstall Avisynth and reinstall RB using the full installer. It will install Avisynth.

 

Same thing happens.

 

I did a little searching and all I could come up with is that DVD-RB shuts down when the user has an unregistered version. You may have to contact jdobbs.