STARVIEW UPDATING FIRMWARE - NO CODE BEGGING HERE

i think you have been answered on the other thread you asked on

here
http://forums.afterdawn.com/thread_view.cfm/3/664977#4060008

 

Turn it off from the back switch and then back on. Turn emu back on and check again.

 

nah still nothing! Should I turn the box off at the back at some point?? would that help?

 

Emm think I said that above??

 

Maybe if he stuck to one thread he would be better off

 

yeah just done that there and still nothing, it just keeps updating constantly.

 

did you go to menu 1570 and press the default key and let it up date then

 

Yep, it updates to about 100% or 250% then flicks back to the channel but still nothing. It just keeps doing that.

 

ok i would reckon you have either not flashed with the correct firmware or it needs to be done again where did you get the firmware from that you flashed the box from

this link is for the genuine box V4.00

http://www.4shared.com/file/46699827/b260d1ca/CryptStar-v14-Core400.html?dirPwdVerified=2e022dc3

this link is for the clone safe V2.57

http://www.4shared.com/file/44560665/dccfe334/CryptStar-v14-Core257.html?dirPwdVerified=2e022dc3

 

Is there an echo in here

 

Got it here, emo's? library...tried a few different ones but they didnt seem to work, so asked a couple of questions here and was sent a link to the correct one. I'll try flash it again and see if that helps.

 

quite possible alright but it just aint getting thru

 

Its getting through alright...thanks!

 

hi again, still have more or less the same problem. I have re-downloaded and re-scanned with latest firmware, seemed ok, even tried the 'bad flash' technique which also seemed to work ok. Uploading the channel file after scanning failed repeatedly. I think the channel download / upload might have messed the box up originally. Autoscan still gives about 20 channels. Tried default & factory reset. Update goes to 100%. Sound sometimes on or off (off at the moment). Sorry to say, totally fed up. Missed Stockport County as well. Perhaps it is just a bad cable connection. Any ideas?

 

Menu > Factory Setting
PIN 0000
OK to delete

Turn box off at the back for a minute and turn back on

English > Installation
Choose Provider etc
Automatic Scan
Press OK
Channels found
Exit

Press Menu then 1570
Turn EMU key ON

Exit , exit , exit

Scan on all providers as CC has aligned some areas try telepest and N*L

Make sure your incoming cable is in the "Cable Input" socket at the back of the Starvi*w

 

hi im tryin to flash my box. i have starview genuine. i have the cables and connect but when i go to download nothing happens. im using a laptop with the usb convertor and wondered if this matters. has anyone used a laptop to flash. please help any suggestions would be great.

thanks

 

if you go to the eko site there is plenty of tutorials in there for you just download and read them there and you will understand it better

http://eko.4shared.com/

 

go to page one of this thread and read the third post down to check and see if you have your box set to the correct port

 

hi i've followed everything. and i have the right port. has anyone flashed using a laptop. the laptop recognises the cable when its in the box but when i find the bin file and click download it just stays on 0%. I've flashed before using pc no probs so am just wondering if anyone has used a laptop

 

yeah lots seems to be easier to use a pc preferably one with a serial port