opening my ps2
#1
28 Jun 2004 @ 10:19
Xman2004
Send private message to this user
Member
i just opened my ps2 to install a flip top cover. Every guide I read told me to be careful of the delicate wire that joins the cover to the base. I accidentally took the wire out. It didn't rip, but it came out. Any help on putting it back in because there are no signs of tear anywhere??? Also does anyone know what the wire is for???? Any help would be greatly appreciated.....Thanks
#2
28 Jun 2004 @ 12:43
zxspeky
Senior Member
that cable joins the reset/eject button to the main board, which end did it come awy from? the case end or main board. if it was from the main board it's a bit tricky, you will need to remove the screws that hold down the dvd tray and, holding the end of the ps2 where the cable came from lift the oposite side of the dvd tray up and towards yourself, so you don't pull out or damage the cable that runs from underneath the tray to the main board, then next to where that cable plugs in is a slot for the your cable.
if it has come from the other end then you have to remove the reset/eject buttons anyway to fit in your flip top, when you take them out you will see where it goes.
if it has come from the other end then you have to remove the reset/eject buttons anyway to fit in your flip top, when you take them out you will see where it goes.
#3
28 Jun 2004 @ 16:17
thnks a lot...it was removed from the motherboard...and i got it fixed...thnks a lot for the help
Share this
