1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

360 Slim Wont Power Up

Discussion in 'Xbox 360 - Modding & Hacking' started by angel_t65, Nov 13, 2011.

  1. angel_t65

    angel_t65 Member

    Joined:
    Nov 13, 2011
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    11
    My slim xbox 360 wont power up, neither with the controller or the power button, I used a different power supply and still no power up.

    I had someone test it and the voltage to the power button and remote receiver is 1.3 volts.

    The guy that tested it is not certain if 1.3 volts is the correct voltage to the power button he think it should be 3.3 volts.

    I need help with the correct voltage to the power button and if it is 3.3 volts, please show me what capacitor or other electronic component controls the current going to the power button.

    I attached this image that I found on another (Cant post images follow the image link below), so that you can use it to point at the wright location so that the problem I am facing can be solved or at least identified.

    http : // img855.imageshack.us/img855/6466/pointso .jpg


    My xbox has no warranty and I am in Panama so sending it to MS is out of the question.
     
  2. peluynati

    peluynati Regular member

    Joined:
    Nov 18, 2009
    Messages:
    1,841
    Likes Received:
    0
    Trophy Points:
    46
    check the mosfet behind the power button, it should be 3.3v
     
  3. angel_t65

    angel_t65 Member

    Joined:
    Nov 13, 2011
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    11
    Thanks will check that tomorrow.
     
  4. angel_t65

    angel_t65 Member

    Joined:
    Nov 13, 2011
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    11
    Ok,the voltage should be 3.3 volts.

    I need to know where to find the capacitor, mosfet or whatever thats the source of the 3.3 volts going to the power and eject button, there is not enough power to these buttons so the xbox can not power on when they are activated.

    The mosfet shown in this image are for the said buttons they have 1.3 volts on stand by. (As a new member I cant post images, just copy the url and eliminate the spaces and you'll be able to link to the image)

    http : // img406.imageshack.us/img406/8155/mobof .jpg

    All help will be appreciated.

    Thanks a lot
     

Share This Page