Adjusting gamecube laser, is it safe?

Hi, i just installed a modchip on my gamecube (xenogc), i did it myself and trying 5 dvds so far, i burned the dvds on some ridata 4x dvdr and they all work, but I'm getting read erros in zelda TP (its always on the same place, when i try to open a door) and in metal gear solid.

So i tried ajusting the laser, and i read that 200~250 is a good value, but when i used the multimeter it was already on 136, then i changed it to 100.

The question is.. is 100 too low? will i have problem if i keep this value? Even with 100 the erros on zelda and metal gear still happens, so i think the problem can be the dvd and not the laser.

What do you guys think?

 

Yes, 100 is too low. Set it to 200 and you should be fine...

Burn games at x2 speed as well

 

thanx, i think the problem is the mini dvdr i burned the game, because the error always happens on the same place.

I'll set my pot to 200 before playing again