1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

benq pcb wiring

Discussion in 'Xbox 360 - Modding & Hacking' started by scoot89, Nov 8, 2011.

  1. scoot89

    scoot89 Member

    Joined:
    Oct 24, 2011
    Messages:
    13
    Likes Received:
    0
    Trophy Points:
    11
    the other day when i was trying to figure out why my xbox 360 dvd drive laser wasnt moving i removed the drive only to find out the s3 wire on the back of my benq drive had come off the pcb board. does that wire make a difference if not connected? if so would it possibly be the reason my laser isnt moving? also can i take my worm motor from my old benq drive and swap them out? any help is greatly appreciated

    Scoot89
     
  2. scoot89

    scoot89 Member

    Joined:
    Oct 24, 2011
    Messages:
    13
    Likes Received:
    0
    Trophy Points:
    11
    i soldered the wire back to the pcb board but still no luck getting jungle flasher to detect my drive :(
     

Share This Page