1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Benq vd6038 laser eye problems

Discussion in 'Xbox 360 - Modding & Hacking' started by bigfrost, Sep 19, 2012.

  1. bigfrost

    bigfrost Member

    Joined:
    Apr 12, 2008
    Messages:
    30
    Likes Received:
    0
    Trophy Points:
    16
    I bought three laser eyes for my benq installed each and every and none of them work. When i put in a disc it just says reading after about 15 to 30seconds says open tray, I cant go back to my old one because its doing same thing now before i installed the eye i desolder the static ball on it can someone help me please.

    Now im doing the pot tweak trick but when i touch the multimeter to its jumping all over the place it goes to one xx.xx n starts going down but i cant get a correct read am i doing something wrong
     
  2. peluynati

    peluynati Regular member

    Joined:
    Nov 18, 2009
    Messages:
    1,841
    Likes Received:
    0
    Trophy Points:
    46
    if its running for 30 seconds before open tray, there could be a lot of problems, start by cleaning your laser really good with alcohol and a cue tip, if that does not do the trick check other things out, i would start by looking at the white plastic clip that goes on the wormgear, make sure you didnt lose the spring out when you changed it to the other laser!
     
  3. steo2k8

    steo2k8 Regular member

    Joined:
    Mar 29, 2008
    Messages:
    1,370
    Likes Received:
    0
    Trophy Points:
    46
    I had one like that, make sure the disc is spinning straight and not at an angle. I had one with a bent motor and the disc was spinning side to side wobbling and after trying 2 lasers I figured it out.
     

Share This Page