1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Borked wiikey install, Help needed - FIXED

Discussion in 'Nintendo Wii / Wii U' started by boblibob, Feb 14, 2008.

  1. boblibob

    boblibob Member

    Joined:
    Aug 29, 2005
    Messages:
    14
    Likes Received:
    0
    Trophy Points:
    11
    So i was installing my wiikey (with wires) and accidentally tugged one of the wires. it lifted up te solde point and the VERY THINg cable oing to the chip, but was still attached, then i did it again. now the pit i pulled off is

    http://www.ps2cover.com/images/articles/wiikey-nintendo-wii-board-zoom.gif

    number 5.

    anyway to un-bugger my wii ?

    NOTE: DMS Chipset, PAL Launch unit

    EDITTOOOO

    i manged to follow the line on the mobo back to the chip, and pry up the pin, i soldered a wire from the pin to the wiikey, i just tested with an original mario strikers, booted and played fine :D

    SOLVED
     
    Last edited: Feb 14, 2008
  2. juniR

    juniR Guest

    I'd edit your post - some language is not accepted here ;)
     

Share This Page