1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

burnt game dont work

Discussion in 'DVD±R media' started by neofytou, Jun 8, 2003.

  1. neofytou

    neofytou Member

    Joined:
    Jun 8, 2003
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    11
    i need help. i burnt a game on to a DVD-R and went to play it and it didnt work. what could be the problems? plz help
     
  2. Oriphus

    Oriphus Senior member

    Joined:
    May 31, 2003
    Messages:
    6,011
    Likes Received:
    0
    Trophy Points:
    116
    You need to be more specific! What platform are you trying to play the game on. What did you do to burn it. If it was a copyright protected disc and you didnt rip it, then you will have problems.

    List the steps you took in creating the disc and the error you recieved.
     
  3. neofytou

    neofytou Member

    Joined:
    Jun 8, 2003
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    11
    basically all i did was place the ps2 game into my burner and made an exapt copy of the game to a DVD-R. i think the chip i have in my ps2 is an ar2 or something along the lines of that.
     
  4. kinel

    kinel Regular member

    Joined:
    Jan 4, 2003
    Messages:
    240
    Likes Received:
    0
    Trophy Points:
    26
    try this booting procedure hope it works Note: You must have GS2 v2.xx or AR2 v2.xx to do this.

    Step 1
    Turn on the PS2 and insert the GameShark2 v2.xx or Action Replay 2 v2.xx CD and turn off the PS2 for about 2 seconds.

    Step 2
    Press and hold the reset button on the PS2 and wait for the GS2/AR2 to load to the main menu.

    Step 3
    Press Eject (do not release Reset untill step 8)

    Insert a DVD game. It must be larger in size than the DVD-r

    Press Eject or push the CD Tray shut

    Step 4
    Wait 10 seconds then select Gameshark Codes

    Step 5
    Add a new game to the codes list. When you are done a message should pop up and the disc should have stopped spinning. You have to do the next step fast, before the message dissappears (it might stay on screen untill you hit a button, I'm not sure)

    Step 6


    Release reset now and insert your DVD-r during the 4 seconds before the tray closes again.

    Step 7
    Hit Start on the controller. (or go back to the main menu and hit start if nothing happens)

    Step 8
    Hit X to select Without Codes then hit X again.

    Step 9
    You should be at the Insert game screen. Hit X to play!

     
  5. boriqua

    boriqua Guest

    What software are you using to burn. I have used NERO to make a copy of a PS2 game, and it did NOT work even though it copied perfectly. I would suggest RecordNow Max. I would just copy a game on the fly and that would work on the PS2...
     

Share This Page