1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

CloneDVD2 error

Discussion in 'Copy DVD to DVDR' started by pisciotj, Apr 10, 2007.

  1. pisciotj

    pisciotj Member

    Joined:
    Mar 3, 2007
    Messages:
    9
    Likes Received:
    0
    Trophy Points:
    11
    I have been using CloneDVD2 for a while now without any problems...other than one binkie7 fixed for me. Thanks again! Anyway, I'm getting a cycle redundency error now. Tried cleaning the DVD but no luck. So far, it's only happened to one I'm trying to burn and not the others. Any sugesstions would be greatly appreciated.

    Thanks
     
  2. binkie7

    binkie7 Moderator Staff Member

    Joined:
    Feb 12, 2005
    Messages:
    17,588
    Likes Received:
    0
    Trophy Points:
    116
    Hi pisciotj
    Sounds like since your using anydvd & clonedvd this error is more due to the condition of the disc. Since you cleaned it are there any visible scratched?

    Have another drive you can try and rip in - some are better then others at ripping these.

    Still a no go - try ripper w/ DVDFab Decrypter (free) - link

    Let us know how it turns out.
     
  3. pisciotj

    pisciotj Member

    Joined:
    Mar 3, 2007
    Messages:
    9
    Likes Received:
    0
    Trophy Points:
    11
    Thanks binkie! The disk was very clean and I'm surprised it didnt work. I downloaded the DVDfab decrypter and that didnt work either. Must just be a bad disk. Thanks for the suggestion though.

    pisciotj
     
  4. binkie7

    binkie7 Moderator Staff Member

    Joined:
    Feb 12, 2005
    Messages:
    17,588
    Likes Received:
    0
    Trophy Points:
    116
    Not a problem pisciotj - too bad that didn't do the trick though.

    You're right - you may have a bad disc cause there's really nothing AnyDVD & CloneDVD can't handle.
    Best bet may be exchanging it for a new one.
     
  5. pisciotj

    pisciotj Member

    Joined:
    Mar 3, 2007
    Messages:
    9
    Likes Received:
    0
    Trophy Points:
    11
    A new one is currently on the way!

     
  6. binkie7

    binkie7 Moderator Staff Member

    Joined:
    Feb 12, 2005
    Messages:
    17,588
    Likes Received:
    0
    Trophy Points:
    116
    Keep us posted on how that one turns out - good, bad or otherwise :)
     
  7. pisciotj

    pisciotj Member

    Joined:
    Mar 3, 2007
    Messages:
    9
    Likes Received:
    0
    Trophy Points:
    11
    Will do!!
     

Share This Page