1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Cyclowiz v2 = Good, but extra hex Nuts from my Wii?

Discussion in 'Nintendo Wii / Wii U' started by ezwii, Jun 26, 2007.

  1. ezwii

    ezwii Member

    Joined:
    Jun 26, 2007
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    11
    I recently installed a Cyclowiz v2, and so far am very satisfied. My working backups (Verbatim -R media) include Raving Rabbids, Super Paper Mario, and the brand new Big Brain Academy and Resident Evil 4. Only problems are minor stuttering in some movies, but gameplay has been fine.

    The problem is that after I reassembled my Wii, I found 2 hex nuts on the floor. I did not actively remove them, so I assume they simply fell out during disassembly. Anybody have any idea where they should go? Even though my system works, I'm afraid I'm doing long-term damage if I leave them out.

    NTSC Wii, DB2 chipset

    [​IMG]
     
  2. lv44

    lv44 Member

    Joined:
    Jun 14, 2007
    Messages:
    22
    Likes Received:
    0
    Trophy Points:
    11
    I BELIEVE those nuts are holding some of the screws in the wii. I think they fell when you removed a cd loading faceplate. I had similar one falling out on me too.
     
  3. jnaks

    jnaks Regular member

    Joined:
    May 30, 2007
    Messages:
    144
    Likes Received:
    0
    Trophy Points:
    26
    more than likely, at least one of them will come from the lithium battery area. there is a slot opposite of where the external battery screw is. it slips into the slot. the other one might come from one of the lower connections to the dvd drive area.
     
  4. ezwii

    ezwii Member

    Joined:
    Jun 26, 2007
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    11
    Thanks guys, I'll check those places.
     

Share This Page