1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Damaged A point

Discussion in 'Nintendo Wii / Wii U' started by backyboy, Mar 16, 2007.

  1. backyboy

    backyboy Member

    Joined:
    Apr 18, 2004
    Messages:
    81
    Likes Received:
    0
    Trophy Points:
    16
    Oops
    Just tried to instal my cyclowiz, got it all wired up, working LED stayed on. Then the cable I used to connect to the chip (used the wired method) ripped the solder from the PCB at point A. Any one got any ideas??? Cant tell if its left anything behind to connect to. I was thinking of using some conductive silver paint to try and make a connection but am unsure if I wil be able to solder to this.
    Cheers
     
  2. backyboy

    backyboy Member

    Joined:
    Apr 18, 2004
    Messages:
    81
    Likes Received:
    0
    Trophy Points:
    16
    I am sure the A B & C solder points are just extensions of the legs of the chip near it, has anyone tried to connect direct????
     
  3. killa024

    killa024 Member

    Joined:
    Mar 16, 2007
    Messages:
    44
    Likes Received:
    0
    Trophy Points:
    16
    Yes, trace the pad back to the chip and solder directly to the chip. But dont mess that one up or your screwed.
     

Share This Page