1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

DEAD xbox after install

Discussion in 'Xbox - Hardware boot discussion' started by slave, Nov 24, 2004.

  1. slave

    slave Member

    Joined:
    Mar 18, 2003
    Messages:
    50
    Likes Received:
    0
    Trophy Points:
    16
    hi
    just installed a xecuter 2.6 pinheader into a 1.2 - 1.5 xbox . i went to power it up and there was no life . only thing i could hear was as soon as i pressed power a slight click sound can be heard , as if it's trying to start , took out chip and same happens still no power and the same sound can be heard everytime you press the power button . i 've checked all wire's and they are connected
    any help plz
     
  2. slave

    slave Member

    Joined:
    Mar 18, 2003
    Messages:
    50
    Likes Received:
    0
    Trophy Points:
    16
    i dont think this might be the cause i doubt it
    i used a mains cable from 1.1 to power it up not its original power cable . the diffwerence in these cables is theres a bigger knob thing on the wire where it plugs into xbox than the orignal power wire .so ill test original cable out tommorrow

    CAN YOU TELL IM A NOOB
     

Share This Page