1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

DMS3 install help

Discussion in 'PS2' started by Warpz, Aug 17, 2003.

  1. Warpz

    Warpz Member

    Joined:
    Aug 17, 2003
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    11
    I have just finished installing my dms3 v2 into my v8 ps2 and it boots to a black screen.
    I used 30 awg for all wires except for power and ground. the ground is under 2 cm. my D and E wires are isolted. all wires are flat against board. Any help would be greatly appreciated. Thanks.
     
  2. robert34

    robert34 Guest

    i think you have to put electric tape on the two wires, because they interfere.
     

Share This Page