1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

dms4., e.z.i. completly solderless mod installation guide!

Discussion in 'PS2 - Hardware boot discussion' started by punx777, Jan 25, 2005.

  1. punx777

    punx777 Regular member

    Joined:
    Mar 2, 2004
    Messages:
    513
    Likes Received:
    0
    Trophy Points:
    26
  2. chaseacej

    chaseacej Member

    Joined:
    Oct 12, 2004
    Messages:
    64
    Likes Received:
    0
    Trophy Points:
    16
    You dont have to have it there. The battery can most likely be removed once the chip is installed and working and the test panel could maybe even be hidden or removed.
     
  3. t0nyj0nes

    t0nyj0nes Guest

    It doesn't look complicated at all, you clip on two chips and plug a ribbon cable into a little connector...


    Plus that image makes it seem like you need that test chip there. Once you install the chip, you plug it into that test panel and power it with a 9v battery or adapter to make sure its working. You can then get rid of it, once you make sure the chip is working...

    It's not really meant to stay there like that....
     
  4. Dix_Fix

    Dix_Fix Regular member

    Joined:
    Jan 2, 2005
    Messages:
    234
    Likes Received:
    0
    Trophy Points:
    26
    The DMS4 Ezi doesnt have to have the light panel left on the machine after installation. The DMS4 Ezi site said that they forgot to put that in the installation guide. They are going to add this info. You dont need to even connect it at all they said it is only to check the install then you can put it in your PS2/Two box or where ever you keep all your other redundant stuff.
    Freeball'in
     

Share This Page