1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

DMS4 Solder Points Help

Discussion in 'PS2 - Hardware boot discussion' started by trdalbee, May 1, 2005.

  1. trdalbee

    trdalbee Member

    Joined:
    Mar 22, 2005
    Messages:
    8
    Likes Received:
    0
    Trophy Points:
    11
    Ok everything went well until the top side of the board (heatsink side) I have a v4, no gap bios. There were 3 solder points but the wire i used were not that flexible, so when i try to run the wires to the other side by bending them, one of the solder points came off. Then i look at it and it pulled the copper with it off too! i was wondering if i can find an alternate solder point for it and i can try to connect thr two points together and then to the chip. It is the "O" soldering point. please help
     
  2. trdalbee

    trdalbee Member

    Joined:
    Mar 22, 2005
    Messages:
    8
    Likes Received:
    0
    Trophy Points:
    11
    oh yes, i have the Pro version
     

Share This Page