1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Duo 3 @ V14: Do not start...

Discussion in 'PS2 - Hardware boot discussion' started by Andrewz, May 5, 2007.

  1. Andrewz

    Andrewz Member

    Joined:
    May 5, 2007
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    11
    Hi there!

    I was wondeing if anyone of you, who installed Duo 3 on V14 got in to the same issues. Sorry, if this is already discussed, just cannot find it...

    I just installed Duo 3 on V14 and after that it refuses to start at all. On the first start it was blinking with green power LED, but after that no matter what disk I'm using (original or backup), it just turn on and immediately turns off. No output on TV, no CD spin. Feels like it tries to start, but then immediately turns off (to red).

    I double checked wiring (no bridges, all points sonnected correct), and just can't figure out what could it be.

    Can someone give a good piece of advise to a noob like me what should I check next?

    Thanks a lot!
     
  2. TeamDX

    TeamDX Member

    Joined:
    Sep 12, 2006
    Messages:
    17
    Likes Received:
    0
    Trophy Points:
    11
    Try and remove the modchip, to confirm the PS2 is still working. If it does, slowly resolder it back on, and double check the motherboard version to the diagram. Because I know there are about 4 types of v14 motherboard versions.
     

Share This Page