1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

DVD SHRINK BURNS SLOW: Solution

Discussion in 'DVD Shrink forum' started by Bukem00, Jan 2, 2005.

  1. Bukem00

    Bukem00 Member

    Joined:
    Dec 31, 2004
    Messages:
    9
    Likes Received:
    0
    Trophy Points:
    11
    PROBLEM)) Starting the beginning of this week the encoding [DVD Shrink] and burning [Nero 6 w/ Sony DRU 530A burner] process I have been using have suddenly ground to a slow crawl. When first installed and up to the beginning of this week, I could analyze and encode in about 1-2 hours (depending on if you deep compression) and then burn in about 20 minutes... Now, for some unknown reason, it takes over 1 hour to burn

    SOLUTION))Check your primary and secondary IDE channels. If any of them do not say ULTRA DMA then uninstall them and reinstall. Even if they do say ULTRA DMA you may want to uninstall and reinstall anyway sometimes it shows ULTRA DMA but it really is not. The slow performance is usually a dead give away for this. I have had this problem a couple times now and uninst/reinst fix's it everytime. Hope this helps.

    PROCEDURE))
    Uninstalling Your Drive(s)
    (1) Go to “Control Panel”
    (2) Double click on “System”
    (3) Click on “Hardware” tab
    (4) Click on “Device Manager”
    (5) Click on the “+” beside IDE ATA/ATAPI Controllers
    (6) Right click on “Primary IDE Channel”
    (7) Then Click on “Uninstall”
    (8) Repeat steps 6 & 7 for each IDE Channel
    (9) Then click on the little “+” beside DVD/CD ROM Drives
    (10) Uninstall your drives in the same manner as described in 6 & 7 above
    (11) Exit out of Device manager and restart your system
    (12) Let Windows install your drives automatically
     
  2. rroettger

    rroettger Regular member

    Joined:
    Sep 3, 2004
    Messages:
    395
    Likes Received:
    0
    Trophy Points:
    26
    DVD Shrink does not burn.
     

Share This Page