1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

e3 questions

Discussion in 'PS3 - Modding & Hacking' started by thatguy269, Nov 21, 2012.

  1. thatguy269

    thatguy269 Member

    Joined:
    Nov 21, 2012
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    11
    I'm think about getting a e3 flasher for my fat ps3 cechk01 but I'm not sure if I need the limited or just the e3 standardith sata cable and after downgrade can I put the hdd back in the ps3 and take out the e3
     
  2. AfterDawn

    AfterDawn Advertisement

  3. Cyprien

    Cyprien Active member

    Joined:
    Nov 2, 2003
    Messages:
    2,027
    Likes Received:
    0
    Trophy Points:
    66
    you don't need the limited.... the normal will do fine.. the limited is only good if you run 2 different firmwares... you also need the downgrade dongle... follow these steps and you will be fine...

    install flasher
    read nor chip
    check file
    patch file
    flash back to nor chip
    power on the ps3 and wait for the missing hdd message to see it if it working
    remove flasher
    put the hdd back
    put in the dongle(this is the only time you will use it)
    power on(power then eject) it will beep and turn off
    now ps3 in service mode
    remove dongle
    put desired firm(must be 3.55 rogero) with the proper lv2diag.self on usb
    plug in the usb in the ps3
    power on ps3 and it will do the rest
    after its done it will turn off
    remove usb power on
    if everything went fine you will be in the XMB with red box saying service mode
    turn if off again
    put the other lv2diag.self file on usb
    plug usb and power it on
    after all this just remove the usb and power cycle the ps3
    congrats ps3 is now downgraded lol
    d(^__^)b
     

Share This Page