1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Error when using xread command MS28

Discussion in 'Xbox 360 - Modding & Hacking' started by london82, Jul 6, 2007.

  1. london82

    london82 Member

    Joined:
    Jul 1, 2007
    Messages:
    42
    Likes Received:
    0
    Trophy Points:
    16
    Hi guys let me ask your help all, not sure if anyone else has had this problem.

    ok i am using extreme boot maker and xtream 52 to flash my ms28

    i create a boot disc to my C: drive using XBM 5.3 and i apply bokes patch.

    Now i boot into dos and Type xread ....... .....(serial)
    it lists my sata card
    i press option 2 for my card and it does the following

    Reading......01% control-break pressed. terminate batch file
    'C:\XTREME\XREAD.BAT' (YES\NO\ALL) ?

    so not sure what to do, i tried no and it comes up with

    Orig.bin is not 256kb in size aborting.


    PLEASE GUYS I NEED YOUR HELP. AM I USING THE RIGHT FIRMWARE AND XBM AND THE RIGHT SETTINGS.

    PLEASE HELP
     
  2. shinnster

    shinnster Regular member

    Joined:
    Oct 30, 2002
    Messages:
    877
    Likes Received:
    0
    Trophy Points:
    26
    How big is your hard drive, it has been know that if you have it larger than 4 gig then it may not owrk and you will need to make a partition and put the files on there instead.

    as I said in your other post, dont use the xread/ xhack way as its not too good, IMO, Use PS2's guide on here to flashing ms28 or get textbooks tutorial and it will tell you step by step.
     
  3. london82

    london82 Member

    Joined:
    Jul 1, 2007
    Messages:
    42
    Likes Received:
    0
    Trophy Points:
    16
    ok my hard drive is 250gb

    and it just dont want any. is it easier to use a floppy

    ok i will read PS2's guide
     
  4. shinnster

    shinnster Regular member

    Joined:
    Oct 30, 2002
    Messages:
    877
    Likes Received:
    0
    Trophy Points:
    26
    I always use a floppy drive and never have any problems.
    it is wise to use a new disk though.
     
  5. london82

    london82 Member

    Joined:
    Jul 1, 2007
    Messages:
    42
    Likes Received:
    0
    Trophy Points:
    16
    ok i use ps2's guide and when it gets to the reading part it only reads 0.1% then it stops and does nothing

    is this due the timing of turning the xbox back on

    i have tried 5 secs, 10 secs and 15 should i wait longer

     
  6. shinnster

    shinnster Regular member

    Joined:
    Oct 30, 2002
    Messages:
    877
    Likes Received:
    0
    Trophy Points:
    26
    hmm, i am not sure that happens, i normally wait 10-12 secs turn it on and it flashes fine. Are you using the via 6421 chipset? you will need that sata card in order for it to flash i believe.
    maybe someone else has come across this and can shed some light on the subject :-(
     

Share This Page