1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

failed repair...HELP!

Discussion in 'PS2' started by dcmk, Mar 23, 2005.

  1. dcmk

    dcmk Member

    Joined:
    Dec 30, 2004
    Messages:
    20
    Likes Received:
    0
    Trophy Points:
    11
    i was experiencing DRE so upon reading some of your posts looked like the laser arm had gone, since replacing found the original arm was fine, but now putting it back together it wont load any disc, it speeds up stalls, speeds up again...continuous cycle.

    a few noises are experienced, like chugging for 3 seconds to speed up disc again...help please
     
  2. steimy

    steimy Active member

    Joined:
    Dec 2, 2004
    Messages:
    12,030
    Likes Received:
    1
    Trophy Points:
    96
    sounds like a laser alignment problem, thats what mine did when the laser was going bad. It would spin real fast and then it would slow down on a cycle.
    And none of my games would load, just the browse screen. try adjusting the laser.
     
  3. dcmk

    dcmk Member

    Joined:
    Dec 30, 2004
    Messages:
    20
    Likes Received:
    0
    Trophy Points:
    11
    how do i go about that exactly?
     
  4. steimy

    steimy Active member

    Joined:
    Dec 2, 2004
    Messages:
    12,030
    Likes Received:
    1
    Trophy Points:
    96

Share This Page