1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Flashing LT+ 2.0 Dash: 2.0.14699.0 RROD

Discussion in 'Xbox 360 - Modding & Hacking' started by marcusj0015, Dec 9, 2011.

  1. marcusj0015

    marcusj0015 Regular member

    Joined:
    Oct 12, 2010
    Messages:
    196
    Likes Received:
    0
    Trophy Points:
    26
    Tried flashing my Xbox 360 to LT+ 2.0 on Dash 2.0.14699.0
    my drive is a LiteON 74850c, and i did the tray fullly open case off the drive, and it tried pulling in the etray, i held the tray open, and it RROD?d for the first time ever, rebooted a few minutes later, immediate RROD again.

    What The fusk do I do?
     
    Last edited: Dec 9, 2011
  2. marcusj0015

    marcusj0015 Regular member

    Joined:
    Oct 12, 2010
    Messages:
    196
    Likes Received:
    0
    Trophy Points:
    26
    The strange thing is, this is the first time this has ever happened. and it's clealry not a heat issue.

    ~EDIT~



    I unplugged the power brick which has a red light, and plugged it back in, all is fine now.
     
    Last edited: Dec 9, 2011
  3. Co45

    Co45 Regular member

    Joined:
    Mar 19, 2006
    Messages:
    248
    Likes Received:
    0
    Trophy Points:
    26
    whats your error code?
     
  4. marcusj0015

    marcusj0015 Regular member

    Joined:
    Oct 12, 2010
    Messages:
    196
    Likes Received:
    0
    Trophy Points:
    26
    There was no error code, it just turned off the display and blinked the RROD lights.
     
  5. Co45

    Co45 Regular member

    Joined:
    Mar 19, 2006
    Messages:
    248
    Likes Received:
    0
    Trophy Points:
    26
    next time your box is shooting you red ring

    Press and hold the sync up button (the small white one), while holding that button press the eject button.
    The LEDs will now blink the first number in the code (as described below).
    Release the eject button and press it again.
    The LEDs will now blink the second number of the code.
    Release the eject button and press it again.
    The LEDs will now blink the third number of the code.
    Release the eject button and press it again.
    The LEDs will now blink the forth number of the code.
    Release the eject button and press it again.
    The LEDs will go back to the 3 red flashing lights

    All four lights flashing - 0
    One light flashing - 1
    Two Lights flashing - 2
    Three lights flashing - 3
     
  6. Modking30

    Modking30 Regular member

    Joined:
    Feb 16, 2010
    Messages:
    3,169
    Likes Received:
    0
    Trophy Points:
    46
    Most likely you got a bad flash to the nand. Resetting the power supply would have drained the power, then updated again.
     

Share This Page