1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

flip top installation problem

Discussion in 'PS2 - DVD backup discussion' started by kvnphm1, Oct 25, 2004.

  1. kvnphm1

    kvnphm1 Member

    Joined:
    Oct 25, 2004
    Messages:
    6
    Likes Received:
    0
    Trophy Points:
    11
    I might have fry my ps2 while trying to install the flip top. I dont now how it happen since i was no where near the power switch. Only problem i had was with the reset/power cable which got in the way and may have got pinch when i close the flip top. Any help is appreciated before i start running getting a new ps2.
     
  2. kvnphm1

    kvnphm1 Member

    Joined:
    Oct 25, 2004
    Messages:
    6
    Likes Received:
    0
    Trophy Points:
    11
    sorry wrong forum... should be in the hardware section. sorry again =(
     
  3. devilhunt

    devilhunt Active member

    Joined:
    Aug 30, 2003
    Messages:
    3,367
    Likes Received:
    0
    Trophy Points:
    66
    if you damaged the reset/eject ribbon then that might be the problem, if this cable is damaged the ps2 won't turn on, what is happening when you try to use your ps2
     
  4. kvnphm1

    kvnphm1 Member

    Joined:
    Oct 25, 2004
    Messages:
    6
    Likes Received:
    0
    Trophy Points:
    11
    nothing is happening. No light no power nothing at all. I'll look over the silver ribbon to see if it is loose but i also knock out the small battery on the side while i was getting the ribbon it fit under the flip top.
     

Share This Page