1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Help after installing the firmware can't decripter or read a DVD

Discussion in 'DVDR' started by Patrick78, May 6, 2004.

  1. Patrick78

    Patrick78 Member

    Joined:
    May 6, 2004
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    11
    Hi,

    I just installed a fireware my dvd ripper an since then, a can't read any DVD on my computer.

    "impossible to activate macrovision"

    And when I tried DVD decripter the message "Invalid or unsupported image file format" appears.

    My DVD decripter is a Sony DRU 500AX
    What can I do.

    Please responde to : patricksamuel@hotmail.com

    thanks.
     
  2. vurbal

    vurbal Administrator Staff Member

    Joined:
    Nov 30, 2002
    Messages:
    3,102
    Likes Received:
    0
    Trophy Points:
    66
    Find an older firmware to install. I don't know what version you had, but you should be able to flash it back to that one. You might have just gotten a bad flash. You could go back to an older firmware and try flashing to the newer one again.

    Oh, and putting your email on a thread is against the rules.

    You should edit that out as soon as possible.
    _
    _X_X_X_X_X_[small]Backup A DVD With DVD Rebuilder & CCE Basic: http://www.afterdawn.com/guides/archive/dvd_rebuilder_tutorial.cfm
    Good Guides To Get You Started: http://www.chrismccann.co.uk/user_guides.htm
    RTFM - not just a good idea, it's the law![/small]
     
    Last edited: May 6, 2004

Share This Page