1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Help, Please, Fliptop Help

Discussion in 'PS2 - Software boot discussion' started by CWolfert, Jul 9, 2007.

  1. CWolfert

    CWolfert Member

    Joined:
    Jul 9, 2007
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    11
    Okay, you guys might think I'm a complete idiot, and I probably am, but

    I was installing my new Flip Top cover, and accidently tugged the end of the ribbon cable that powers the reset/eject thing out of the end connected to the console. It didn't break, it's just pulled out, and I can't for the life of me find where to plug it back in.

    Is there some guide, or some way to get to where to plug it in, and do so?
     
  2. darcnis

    darcnis Member

    Joined:
    Dec 29, 2005
    Messages:
    7
    Likes Received:
    0
    Trophy Points:
    11
    There should be a little clip on the side where it came from. You push the little (brown if I remember correctly) bar down and it allows the ribbon to slide in, then push the bar back up so it clicks and it should be connected.
     
  3. dwaynep

    dwaynep Regular member

    Joined:
    Jul 13, 2007
    Messages:
    117
    Likes Received:
    0
    Trophy Points:
    26
    use tweezers if it helps cuz it helps me
     
  4. ucdrew

    ucdrew Member

    Joined:
    Jan 6, 2006
    Messages:
    29
    Likes Received:
    0
    Trophy Points:
    11
    it may be easier to see if u pull the whole ps2 out of the case you would have to remove the screw over by the memory card first then lift it out and you should have better access to the area now
     

Share This Page