Using two drives, 10 mins to rip two movies with Dycrypter, 15 mins to convert them both with DVD2One and 40 mins to burn them with RecordMax.
I have: P4 3.2 Ghz 1GB HyperX PC3200 RAM 2 37GB 10,000rpm SATA drives for OS 2 250gb 7,200rpm SATA drives for data GeForce 5 5900 Ultra w/256mb ram Plextor P708-A 8x DVD+/- burner DVD2One takes less than 3 minutes on average and approx 7 mins to burn with Roxio 6.
I would also like to know_X_X_X_X_X_[small] XP 2400+ MSI KT4V 256 PC266 DDR RAM 80 GIG IBM 7,200 RPM RADEON 9200 128DDR Pioneer 16x DVD-ROM Pioneer 105 4x DVD-R http://www.mafiabackups.da.ru[/small]
DVD2One and anydvd don't get along with me so it takes 20 min to copy with anydvd 6-7 min for dvd2one(I use my 10k rpm harddrive as source, to a 7.2k rpm destination drive, does wonders) and 20-25 min burning with nero 6.3.0.2 P4 HT 2.4 ghz, 512 MB ram, 10k rpm system drive, 7.2k rpm second drive, radeon 9600 256MB vid ram
DVDdecrypter 10-12 min DVD2one 8-12 min copytodvd burn 13 min If I use anydvd with dvd2one takes 23-28 min
It seems those with bigger memory reserves burn faster. Added to that the burn rate of the writer has a lot to do with it. A tip I picked up here within this site mentions cpu useage. Those that have the wrong settings typically use more cpu useage than those that have it set correctly. I know that there is a lot of difference in speed between my computers in doing the same tasks. The oldest does not have a dvd reader/writer. Takes around 15 minutes to burn a cd. Those with the dvd writers take far less time. As they are newer with faster speed capabilities, I will assume that is the reason for the speed increase. What I have read in this thread, indicates I should buy more memory to see some speed increase in my rates. Thank you all.
A big speed difference when using decryptor/smartripper/etc is that DMA must be turned on. In XP, my setting was turned on, then XP automatically reset it to off. I had to remove IDE controllers and reboot and let it set up again. Then make sure UltraDMA is enabled. When it's on I can get up to 13x and when it's off, less then 3x.
Athlon Barton Core 2500+ 333fsb, OCed to 3200+ 1 gig PC 3200 400mhz DDR 120 gig 7200 Maxtor HD XP Pro Pioneer 106D, with firmware update. Memorex Dvd-r 4x Decrypting = 16 min Dvd2Zone = 15 Min Nero = 14 Min Total time 45 min. I followed the steps outlined in the Dvd-r FAQs to burn my first dvd, which was a dvd-9 format about a diaty who gives his powers to a guy and comic hyjinks ensue. Worked like a charm. Im one for one.
2.6 GHZ PROCESSOR 256MB ram 160 GIG IN HARDRIVES SO FAR DVD DECRYPTER.....Usually about 8 - 11 minutes depending on size of target DVD2ONE ......Anything from 15 to 25 minutes Burning.... 25 minutes for a full disks worth on 2.4 speed
