1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

How to convert PAL vcd to NTSC vcd system?

Discussion in 'Convert DVD to another format' started by Hammorabi, Jan 5, 2005.

  1. Hammorabi

    Hammorabi Guest

    I have a VCD recorded in Pal system and I want to convert it to an NTSC system 'coz my DVD can read this format only.
    And the best way to burn it.

    If any one know how I realy appreciate his help.

    THANX
     
  2. osscar

    osscar Member

    Joined:
    Jan 5, 2005
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    11
    you can do it with the program CANOPUS PROCODER. and ready.
     
  3. ruroni

    ruroni Member

    Joined:
    Dec 22, 2004
    Messages:
    8
    Likes Received:
    0
    Trophy Points:
    11
    prCoder is $500!!!

    Is there another way? I have access to adobe premeire pro v7.0 @ school... And iMovie.. (doubt iMovie could help).

     
  4. man-sd

    man-sd Member

    Joined:
    Feb 27, 2005
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    11
    You can record your movie in Pal VCD and then use free software TMPGEnc 2.5 (www.tmpgenc.net) to convert it from Pal to NTSC format, then burn it to CD by burning program.

    -When TMPGEnc opened, Project Wizard Window will opened, In Video-CD, click NTSC, hit Next.
    -In this window, you need to browse to locate the Pal video file in hard-drive. at the Aspect ratio, choose "4:3 525 line (NTSC, 704x480)" hit next
    -you can ignore the next "filter setting" hit next
    -At Birate window, you need to select the capacity of the CD-rom, in my case = CD-R 80min, hit next
    -At Specifying output file name, you need to browse the place your new NTSC file will be copied to, remember the new place should be not the same folder with the Pal file name. hit OK
    -in the next window, make sure the information in Video source box, audio source box (should be the same with audio source box), output file name are correct, then hit Start. After the program finish decoding you are Done.
    Hope give you some helps, this is the way I do with my Pal Video clips and it works perfectly.

    -

     

Share This Page