Discussion in 'DVD Shrink forum' started by layla519, Jan 24, 2007.
Has anyone burnt the guardian. What did u use?
Try using DVDFab decrypter to rip with then open the files with DVD shrink using it as you normally would.
Did this one with anydvd 188.8.131.52 and clonedvd.
DVDFab3050+VobBlanker+Recode will work for this movie
I used DVDFabDecrypter and Shrink, anydvd always runs in the background. It copied fine.
Burned movie only with Anydvd, Shrink, and Imgburn. Played perfectly.
I wasn't succesfull. Used ANY dvd, recoded with nero. Tried burning to a dual layer dvd. Burn report was succesfull however only plays in french and I didn't change any settings in the process. If I change the language to english or spanish, it still only plays in french. I really don't mind because I am bilingual but I prefer english movies in english.
I really didn't have a chance to watch much of it yet. Will try and report more later.
Well I found that the english audio box was not checked. Will try again.
no problems on this one with Dvd Fab and CloneDVD2. Great movie by the way.
My bad. Tried again with the correct settings checked and voila, all is good. My bad, and yes, good movie. I love my job now.
your job? whats your job?
I used the latest version of ANYDVD, DVD Shrink and Nero. Backed up full disk and have watched it twice with no problems.
Any issues ripping or backing up new released DVDs?
Have a look at some FREE guides here http://www.dvdplusvideo.com/A_F_Guides.html
And here are more guide http://www.dvdplusvideo.com/Guides.html (like Jigsaw said; "pick your choice.")
Best of luck and enjoy them FREE guides!!
rip it, run it through vob blanker, then burn.
I was just commenting on the movie "The Guardian", after watching that movie, I love my job (I don't think I would like to have a job like a coast guard officer.
I used DVDFab Decrypter 184.108.40.206 Beta to rip The Guardian_WS and had no obvious problems. When I run DVD Shrink on it, in re-author mode, and select Main Movie/Title 1 only, no captioning and AC3 5.1 English only. It gets to "X% Encoding" and the entire DVD Shrink window and process disappears.
Heh, it vanished while I was typing this and I was going to watch it to fill in the "X" above. It was at 3% when I started typing, so it couldn't have made it to 4 or 5%.
Any advice or ideas ?? I see many people have had no trouble at all.
It's possible your Shrink is corrupted. I would do an uninstall and then re-install then give it a shot.
It works fine on any other DVD or ISO I've run it on.
Anyone else have any ideas or suggestions ??
use dvdfab new updates and with shrink, these 2 will do the job..
I guess what I'm wondering is, could DVDFab Decrypter miss something that causes Shrink to crash hard ?? From what others have seen, I doubt that's the case. I am using the *beta* of DVDFab though... Are others or are you using the standard release ??
Separate names with a comma.