1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Install wiikey methods

Discussion in 'Nintendo Wii / Wii U' started by jpc1284, Dec 11, 2007.

  1. jpc1284

    jpc1284 Regular member

    Joined:
    Mar 22, 2007
    Messages:
    110
    Likes Received:
    0
    Trophy Points:
    26
    I have seen a couple methods for installing the wiikey. there is the short wire and the long wire. But the one i can never seem to find is the no wire way. is this possible. i have a D2A with all the points there and the legs are not cut. I have a decent experience with solder chips directly to the board. Thats how my PS2 chip installed. Is there any disadvantage besides being harder to remove then a long/short wire method.
     
  2. brido84

    brido84 Regular member

    Joined:
    Dec 21, 2006
    Messages:
    141
    Likes Received:
    0
    Trophy Points:
    26
    Yeah the short wire method was adopted over the no wire method as the WiiKey points don't line up properly with the board and the points are close together and easy to bridge.
     

Share This Page