hi has anybody jtagged a original starview box if so what are the pin config ie ground to what number pin and so on the box i have has only 8 pins thanks in advance
dont know much about jtaging but this might help (thanks to scouser) JTAG GUIDE Build the JTAG as below. JTAG is in the corner of the PCB and is a 20pin connector (no pins, just pads) layed out in a 2 x 10 array. Pin1 is the square pin. Connections are as follows: PIN9 = TMS PIN11 = TCK PIN13 = TDI PIN15 = TDO PIN19 = TRST Ground is all even number pins. VCC is the end of capacitor C40 nearest the processor. The box must be powered up to be flashed (don't worry about the lack of display or picture) Flashing with JKEYS ------------------- Run JKEYS and Detect. Should come up as: Device ID: 0x1D405041 Device: STi5518MVB-X Choose the IRD model as 4900 Flash would be 29LV160 Start : 7FE00000 Bytes 20000 Go into flash programmer. Erase chip first by clicking on Erase in the top right Flash chip with a working TSOP image by clicking on the top-right Program button. Flashing with S*YMax UP (Easier!) -------------------------------- If you are having problems flashing with JKEYS you can also use S*YUP. This is much easier to use. Click on 2mb (0x7FE00000) Click Start Click Erase Click Write Choose your flash image .. sit back and wait Thanks to SunRise Jtag Tut http://www.mediafire.com/?7tzcc4dj3yd SkyMax 2 http://www.mediafire.com/?8fzumnj1k9g Jkeys http://www.mediafire.com/?3z9z322ck2x 260 Jtag Flash Image http://www.mediafire.com/?49jgvte4o0z
thanks for that but you will find that this guide is for the cloned boxes original boxes i have dont have a 20 pin pad or pins it has a 8 pad configuration in the middle of the motherboard
lad on another thread will have more info on jtagin. you will prob find more info here ! http://forums.afterdawn.com/thread_view.cfm/11/531375#3224967
