1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Magic 3.1+ and a blank screen

Discussion in 'PS2' started by bnl1433, Nov 10, 2004.

  1. bnl1433

    bnl1433 Member

    Joined:
    Nov 10, 2004
    Messages:
    7
    Likes Received:
    0
    Trophy Points:
    11
    I just installed my magic 3.1 plus and when i boot the machine up i just get a blank screen. I followed the steps that are required to boot up. The leds work fine, i checked my board for shorts and it looks like my soldering is ok. Does anyone have an idea of what could be wrong?
    fixed.
     
    Last edited: Nov 10, 2004
  2. suki24

    suki24 Member

    Joined:
    Jun 11, 2004
    Messages:
    73
    Likes Received:
    0
    Trophy Points:
    16
    that happen to me....didnt know what was the problem but I mainly focused on the solder for RST,GND,and PWR...and that fixed the problem....

    if you have a blank screen that defientiely means your solders are incorrect....

    worst case is you screwed ur motherboard
     

Share This Page