1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Magic 3.1 problem

Discussion in 'PS2' started by DeTr0iT, Apr 6, 2003.

  1. DeTr0iT

    DeTr0iT Guest

    I just installed a 3.1 into a version 7 ps2.. I can boot up with my original but when i place a dvd-rip game into the ps2 it boots to the brower screen. Then goes to a screen that says "Please insert a Playstation or Playstation 2 format disc."

    Does this indicate that the mod chip is not being recognized?
    any ideas on how to correct this?_X_X_X_X_X_[small]Nothing[/small]
     
  2. JVegas

    JVegas Regular member

    Joined:
    Feb 20, 2003
    Messages:
    261
    Likes Received:
    0
    Trophy Points:
    26
    Mis-install. You need to check the bios points on the PS2 chip. Check for VERY small bridges and GOOD contact. Be sure your contacts are correct.
    j
     
  3. DeTr0iT

    DeTr0iT Guest

    thanks bro.. I'll go over it all again..
     
  4. PS2Gamer

    PS2Gamer Regular member

    Joined:
    Jan 9, 2003
    Messages:
    153
    Likes Received:
    0
    Trophy Points:
    26
    With the magic three there is a boot procedure to go through for backups.
    PS2 dvdr copies - place disc in tray, close, tap reset
    PS2 cdr - same as above, but for some you may have to hold a little longer(according to the quality of cdr)
    PS1 - Insert game, press and hold reset until blue light comes on.

    Hope that helps.
     

Share This Page