1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Magic 3.5 help

Discussion in 'PS2' started by eroc23, Jan 8, 2003.

  1. eroc23

    eroc23 Guest

    How can i bypass the bios clip on a ver 7 PS2??
     
  2. jr_

    jr_ Guest

    I think a 3.5 is just a magic 3 with clips. So just look at the magic 3 diagrams and solder the wires like you were installing a magic 3



     
  3. eroc23

    eroc23 Guest

    it is just a magic 3 with a clip but there are 3 extra wires that I cant match up?
     
  4. freakyg

    freakyg Member

    Joined:
    Dec 19, 2002
    Messages:
    83
    Likes Received:
    0
    Trophy Points:
    16
  5. eroc23

    eroc23 Guest

    that site has good pic but on the chip there are 3 wires that are unidentified. actually one is a ground but I need to know where the other two wires get soldered to. They are below the R wire.
     
    Last edited by a moderator: Jan 8, 2003
  6. jr_

    jr_ Guest

    It looks like to me the clips are an off the shelf item that has more connections than needed. Some of the wires are not used. It depends on the version PS2 you have. You should be able to just trace out where they go. They probably are not used.


     
    Last edited by a moderator: Jan 9, 2003

Share This Page