1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

MOD CHIP intallation HELP!!

Discussion in 'PS2 - Hardware boot discussion' started by sung7psi, Aug 14, 2004.

  1. sung7psi

    sung7psi Member

    Joined:
    Aug 11, 2004
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    11
    trying to install this neo12 modchip in my v9 ps2

    but having difficulty with the last 5 wires left.
    how do i get the FBGHI wires to solder to the back of the motherboard

    they are very very tiny via's and i can't get them to solder to the wires

    any help would be appreciated.
     
  2. daPhoenix

    daPhoenix Guest

    You need to get some flux paste to help the wires stick. plus you have to scrape the via's to clean them off. They habe a lacker covering them that need to be removed. So get a small needle or a fine tip screw driver and gently scrape the lacker off of them. Put a little solder on the tip of the wire and dip it in the flux paste. Then you should have no problem soldering to those little vias.
     

Share This Page