1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Need help. not burning at 8X or above.

Discussion in 'DVD / Blu-ray drives' started by Tex89, Jan 14, 2005.

  1. Tex89

    Tex89 Guest

    I just purchased a Toshiba SDR-5372,updated the firmware, use dvdshrink & dvdcrypter or nero and neither will burn any faster than the 4x I was getting with my old BTC 8x burner. Is there a setting, or different burning software I need. I just need to be pointed in the right direction. I was using Ritek G04's with the BTC and just bought the Ritek G05's for the new burner.
     
    Last edited by a moderator: Jan 14, 2005
  2. Balaam

    Balaam Regular member

    Joined:
    Nov 19, 2004
    Messages:
    715
    Likes Received:
    0
    Trophy Points:
    26
    Make sure your harddrive is set to dma mode and not pio:
    control panel>device manger>ide
    I assume your riteks are 8x.
     
  3. Tex89

    Tex89 Guest

    the IDE Controller ( I assume this is what your talking about?) is set at ultra DMA 5. Riteks are G05 8X DVD-R
     
  4. Tex89

    Tex89 Guest

    I think I found my answer. http://www.ritek.com/products/pro-dvd-rw.htm Go down to compatibility PDF file. I got hooked line and sinker into believing that I might get 8X or even 12X from the burner. If I use Fuji M03 disc, I can get the 8X.
     

Share This Page