1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

"No suitable splitter was found" msg on RadLight while trying to play mp4

Discussion in 'Video playback problems' started by CCEncoder, Dec 12, 2012.

  1. CCEncoder

    CCEncoder Regular member

    Joined:
    Jun 9, 2004
    Messages:
    172
    Likes Received:
    0
    Trophy Points:
    26
    I am using RadLight 4 to play videos as it's my favorite program. From radlight.com
    I have installed quicktime, ffdshow and just installed RadLight but I get the msg while opening file on RadLight:
    # RLGB error : No suitable splitter was found

    The file opens fine on WMP.
    Mediainfo gives the following info about the video content in case you need it:
    AVC (High@L4.0)(CABAC/5 Ref Frames)

    I have tried enabling and disabling codec H.264 on ffdshow but same results, I can even play it on WMP with the codec disabled on ffdshow I believe it's due to having quicktime, there is some graph build needed or some "Source and Splitter filter configuration" to configure here is a screenshot:
    [​IMG]
     
    Last edited: Dec 17, 2012
  2. attar

    attar Senior member

    Joined:
    Jun 17, 2005
    Messages:
    11,147
    Likes Received:
    41
    Trophy Points:
    128
    ffdshow > Video decoder configuration, is H264/AVC enabled?
     
  3. CCEncoder

    CCEncoder Regular member

    Joined:
    Jun 9, 2004
    Messages:
    172
    Likes Received:
    0
    Trophy Points:
    26
    yes it's enabled that's not the problem, it can play fine on WMP I'm sure it's one of the problems mentioned on my post about the graph builder or the spliter source configuration.
     

Share This Page