1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

problem flashing Liteon

Discussion in 'Xbox 360 - Modding & Hacking' started by tgunnz22, Oct 13, 2011.

  1. tgunnz22

    tgunnz22 Regular member

    Joined:
    Jan 26, 2008
    Messages:
    103
    Likes Received:
    0
    Trophy Points:
    26
    OK I have been away from the scene for a while, I'm having problems flashing with JF. I hooked up the liteon to my via sata card opened JF it recognized my drive I went erase it on forgot to power cycle it.Now I have a flashing green light on my Xbox and I cant get JF to recognize my drive.Any help would be appreciated
     
  2. SONA007

    SONA007 Member

    Joined:
    Jun 27, 2011
    Messages:
    33
    Likes Received:
    0
    Trophy Points:
    16
    If you have the DVDKey then you can recover back or else you are SOL.At present the Drive may be without any Firmware so the flashing green lights.All you need to do is to load the Dummy.bin in Source and LT 1.9 or 2.0 in target.Spoof the DVDKey.Select the same Sata Port in jungle flasher that was used initially.The drive may not showup but you can again click on Liteon Erase.Click Yes on first msgBox.Turn off Power to the DVD. Click Yes on 2nd Msg and then turn on Power to the DVD.The drive will be forced in the vendor mode.Once the status changes to 0x72 and Flash Chip Properties are identified you can click on write.Let it complete the write and perform an outro after that. Hope that resolves your issue !
     
  3. tgunnz22

    tgunnz22 Regular member

    Joined:
    Jan 26, 2008
    Messages:
    103
    Likes Received:
    0
    Trophy Points:
    26
    Yeah I have my drive key, I'm going to give it a shot when I get home thanks
     
  4. tgunnz22

    tgunnz22 Regular member

    Joined:
    Jan 26, 2008
    Messages:
    103
    Likes Received:
    0
    Trophy Points:
    26
    It worked just like you said thanks for your help
     

Share This Page