1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Ps2 controller ribbon/slot help! please

Discussion in 'PS2 - Hardware boot discussion' started by jrbooey, Dec 27, 2004.

  1. jrbooey

    jrbooey Guest

    hey i had a fliptop installed on my v7 ps2, and i got Disc read error, so i tried going inside to fix it, but instead pulled the c ontroller ribbon out...i know how to put it back in and i did and it worked fine, but the clip that secured the ribbon broke, i was wondering if there is an alternative way of getting the ribbon to stay in place, i tried tape, but the controllers werent acknowledged....anyone have any experience in this? any help would be appreciated! thanks
     
  2. jrbooey

    jrbooey Guest

    Nevermind I fixed it, i just put the ribbon where it was supposed to be and used a rubber stopper to jam it in there, so it was tight
     
  3. rcade

    rcade Guest

    Put the Ribbon in the slot and try to put it as far as you can. Then get a paperclip to keep it tight. Then just tape it up.
     

Share This Page