1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

ps2 power

Discussion in 'PS2 - Hardware boot discussion' started by smackfrog, Nov 15, 2004.

  1. smackfrog

    smackfrog Member

    Joined:
    Nov 4, 2004
    Messages:
    55
    Likes Received:
    0
    Trophy Points:
    16
    I just took off my ps2 cover as I was going to install a flip top cover. I pulled off the top case, which I have done a couple times already, and the strip connected to the power button came unconnected, its not ripped or anything, but i can't seem to find where to connect it back. I have the bottom of the case off now and I am trying to figure out how this is going to work. Any help would be much appreciated.
     
  2. smackfrog

    smackfrog Member

    Joined:
    Nov 4, 2004
    Messages:
    55
    Likes Received:
    0
    Trophy Points:
    16
    ok i see where the end of the strip is supposed to connect to the board.. but, of course, it won't stay there, does anyone know how i can do this???.. I am desperate here
     
  3. nelswick

    nelswick Regular member

    Joined:
    Jul 24, 2004
    Messages:
    765
    Likes Received:
    0
    Trophy Points:
    26
    you stick the end of the ribbon firmly into the little slot thing.
     
  4. smackfrog

    smackfrog Member

    Joined:
    Nov 4, 2004
    Messages:
    55
    Likes Received:
    0
    Trophy Points:
    16
    ya i ended up figuring it out.. there is a teeny tiny lil like clasp/clamp thing.. thanx anyway
     

Share This Page