1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

ps2 v7 laser problem please help

Discussion in 'PS2 - Hardware boot discussion' started by Powercore, Apr 28, 2005.

  1. Powercore

    Powercore Guest

    I have been having a problem getting my fliptop with swap magic 3.3 cd to boot. I tried adjusting the little white thingy, that helped some. Then I decided to run some other test on it and found that my cd ohms setting wont stay at a stable setting. It's set to around 1126 ohms minute later when I tested it again it was at 1533 ohms. It doesnt matter where I set it (950-1200 ohms) it keeps going up and down. Does anyone have any advise on what I should do next. Laser, Laser ribbon, Power supply?
    By the way I have issues with the dvd stuff at all works great.
     
  2. Powercore

    Powercore Guest

    ANYONE?
     
  3. sui-cyco

    sui-cyco Regular member

    Joined:
    Apr 24, 2005
    Messages:
    929
    Likes Received:
    0
    Trophy Points:
    26
    clean the lens.and adjust the white dial(the lens height)to the original position.
     
  4. Powercore

    Powercore Guest

    Did that.
     
  5. sui-cyco

    sui-cyco Regular member

    Joined:
    Apr 24, 2005
    Messages:
    929
    Likes Received:
    0
    Trophy Points:
    26
    i have know idea what you are trying to say.

    now,did you try both the cd and dvd versions of swap magic to make sure they both work/
     

Share This Page